Caution, Connecting the speaker cable, Twist the wire ends tightly together – Onkyo TX-SR601 User Manual
Page 27: Unscrew the speaker terminal cap, Insert the exposed wire end, Screw down the speaker terminal cap, Connecting speakers
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting speakers
Connecting speakers
After determining the layout of your speaker system, it is now
necessary to connect the speakers correctly to your TX-SR701/
701E/601/601E.
Caution:
• Be sure to connect the positive (+) and negative (-) cables for
the speakei's properly. If they are mixed up, the left and right
signals will be reversed and the audio will sound unnatural.
• Do not connect more than one speaker cable to one speaker
terminal. Doing so may damage the TX-SR701/701E/601/
601E.
• Connect only speakers with an impedance between 6 and 16
Q to the TX-SR701/701E/601/601E. Connecting speakers
with an impedance lower than 6 Q may damage the
amplifier.
• Even if you are using only one speakei' or listening to monaural
(mono) sound, never connect a single speaker in parallel to both
the right and left-channel terminafs.
To prevent damage to circuitry, never short-circuit the positive
(4-) and negative (-) speaker wires.
Connecting the speaker cable
1. Strip away approx. 5/8 inch (15 mm)
of the wire insulation.
2. Twist the wire ends tightly together.
3. Unscrew the speaker terminal cap.
4. Insert the exposed wire end.
5. Screw down the speaker terminal
cap.
s/e"
ri
27