Select options i, Select the signal, Start your maytag neptune® washer – Maytag MAH5500B User Manual
Page 5: Step, Options, Signal g^)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step
S
elect
O
ptions
I
Press the appropriate pad(s) to select one or more options.
presoak - Adds 15 minutes of mostly soaking with minimal tumbling before
the regular cycle. Can be selected with any cycle.
stain cycle - Adds time to the wash and rinses for better stain removal.
Automatically provides a fourth rinse.
extra rinse - A fourth rinse at the end of the cycle to more completely
remove laundry additives and perfumes.
max extract - Use for jeans, towels, and bedding. Removes more water from
loads during spin.
NOTE; To minimize wrinkling of wrinkle free fabrics, using the Max Extract
option with these loads is not recommended.
delay wash — Allows the start of any cycle to be delayed for up to 9 hours.
Make the appropriate selection for your load, then press the delay wash pad
once for one hour or press the pad again to increase the delay wash time up
to 9 hours in one hour increments.
Options
max
3Ct
delaiipsh
Step ^
S
elect
the
S
ignal
Press the “+” or signal pad to increase or decrease the end of cycle signal volume.
signal G^)|
Step
7)
S
tart
Y
our
M
aytag
N
eptune
® W
asher
• Close the door.
• Add detergent and additives to the dispenser (See page 6).
• Push the start/pause pad.
• When the washer is started after a pause, there may be up to a 30
second delay before continuing the cycle.
Pressing off cancels the cycle and stops the washer,
NOTE: When the cycle is complete, the door locked light will go out.The door
will open easily. DO NOT attempt to open the washer door when the door
lacked light is illuminated.To add a forgotten item, see pg. 2.
start/oâuse