Maytag 6 915513 A - Manual (Page 3)

o
Tnols Necessary for Installation
❖
O Cutting Knife
O Ratchet
O 3/16”,1/4”, 5/16” Sockets
O Phillips Screwdriver
O Standard Screwdriver
O Wire Cutters
O Crescent Wrench
O Adjustable Pliers
O Level
Support Accessories:
O 3/4” UL Approved Strain Relief (provided)
O 2 Appropriate Sized Wire Nuts
O 3/8” Male (N.P.T.) Compression Elbow or Flare Elbow
O Thread Sealing Tape or Pipe Thread Compound
O Appropriate Sized Hose Clamp
O 3 Wood Mounting Screws (provided)
C) Drain Hose Retainer (provided)
(Not included: Tools required for
preparing the cabinet opening).
O
Water Hook-Up Kits Available;
(Water line, water valve fitting, Teflon^^^ tape, tee valve fitting)
5’ Braided Stainless Steel Part #19950153
5’ Copper Part #19950152
Available through an authorized Maytag Parts Retailer
NOTE: Make sure you have everything necessary
for proper installation before going to step 2.
o
Uncrating
O Remove access and toe panels before beginning installation.
e Remove bolts from the crate base brackets, using 5/16” socket with ratchet. Remove
crate base and discard base and packaging. Until dishwasher is permanently installed,
beware of opening the door as the unit may tip forward.
® Loosen front leg bolts with a crescent wrench. Adjust rear leg bolts in same manner.
CAUTION: With the door open, dishwasher may tip forward if it is not secure in position to cabinet.
TIP: Pre-measure cabinet height to that of the dishwa.sher. Dishwasher should he 1/4” lower than
that of the cabinet opening. Its easier to adju.st the dishwasher outside rhe cabinet than inside.
J
0
Cabinet Preparation
Prepare cabinet as needed. Electrical and water facilities should enter cabinet opening on the floor, or through the
back or side walls, as shown in the shaded portion of the drawing. Preferred drain outlet is shown in the lower
portion of the cabinet in drawing below. Care should
be taken to route plumbing away from the motor.
DO NOT make connections until dishwasher is in
position. Care should be taken to make sure cabinet
holes for power cord and hoses have no sharp edges.
CUSTOM PANELS AVAILABLE
Dishwashers come with pre-installed panels.
Custom panels are available; stainless steel and
trims kits for wood panels. See your authorized
selling dealer for a complete list of products
available.
cabinet opening dishwasher dimensions