Securing the dishwasher, Drain hose attachment о e – Maytag 6 915513 A User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

о

о

ее

With the door latched, guide dishwasher into the cabinet.

Route water line, electrical supply and drain hose to left side
of motor and above rear support bar.
Front & rear leveling legs position the dishwasher vertically

& horizontally. A combination of these adjustments are necessary
to properly level the dishwasher and to insure proper fit of door
and latch.

Dishwasher must be level, stable and square.

'HP: When installing di.shwashcr near a corner, allow enough room for the door

to open without interfering with any cabinets, drawers, or hardware.

TIP; Di.sretyrd the M]u.irene'>.s ot\.ihinet opening in tvlation ni didiwasher.
The tub side trim may be positioned and/or trimmed to fill gap.

e

Securing the Dishwasher

Make pilot holes in the underside of counter and drive wood screws, provided in
the accessory package, through holes in the dishwasher mounting bracket. If part
of the bracket extends beyond the cabinet front, they may be trimmed with wire
cutters, provided sufficient material is left to support dishwasher mounting.

Note: Dishwasher must be secured properly to countertop to avoid tipping when
the door is open and to prevent the tub from twisting.

О

Solid Surface Mounting:

It may be necessary to provide an additional anchoring source for mounting screws. Wood strips across the top of
the dishwasher opening can be used for solid surface or granite type counters to secure the dishwasher.

TIP: Refer lo eminrerrop m.imifaciurer fur n>m]'leie Jet.iiN on ^ealring ili.sliw.idier lo ((iimien<i|i.

Drain Hose Attachment

о

e

Remove plug from pump drain port. Some water from factory quality testing may drip when plug is removed.
DO NOT remove any other drain parts.
Connect drain hose by sliding hose end over drain port until firmly seated. Position hose clamp so screw head
is on a horizontal plane and faces front of machine. Tighten securely. (Do not over tighten.)

© With dishwasher in permanent position, clamp drain hose to a properly sized drain line.

TIP: If draining into the disposer, cheek to make sure disposal plug has been removed. It not, remove a.s shown.

Advertising