SINGER 114W110 - Manual (Page 14)

(S ee F ig . 4)
The pressure on the presser foot is regulated by the thumb
screw (A, Fig. 4, page 4) at the top of the machine and to the
rear. To increase the pressure, turn the thumb screw over to
the right or downward. To decrease the pressure, turn the thumb
screw over to the left, or upward.
When the machine is being driven slowly, the pressure on the
presser foot should be very light. If the machine is to be driven
rapidly, the pressure on the presser foot should be increased.
To Regulate the Pressure on the Braid Guide
(S ee F ig . 4)
The pressure on the braid guide is regulated by the thumb
screw (C, Fig. 4, page 4) at the top of the machine and to the
front. To increase the pressure turn the thumb screw over to the
right or downward. To decrease the pressure, turn the thumb
screw over to the left or upward.
When the machine is being driven slowly, the pressure on the
braid guide should be very light. If the machine is to be driven
rapidly, the pressure on the braid guide should be increased.
To Adjust the Tension on the Braid Spool
(S ee F ig . 30)
The tension on the braid spool is regulated by the thumb
screw (B, Fig. 30) the end of this screw bearing against the flat
24
To Regulate the Pressure on the Presser Foot
1
F ig . 30. B raid S pool T ension
tension spring (A, Fig. 30). To increase the tension, turn this
thumb screw over to the right or inwardly. To decrease the
tension, turn the thumb screw over to the left or outwardly.
The tension on the braid spool should be just tight enough
to prevent the braid unwinding from the spool when the machine
is stopped suddenly.