Maytag HE21250S - Manual (Page 14)

Converting the Lower Element
(cont'd)
Instructions for Installation (cont'd)
7. The wire removed from terminal 2 has a looped end. It
must remain looped and now be placed (as shown) on top
of the buss bar, over the opening of terminal 2, and secured
using the remaining screw.
11. Replace the access panel.
8. Tighten terminals 2 and 3 to ensure proper electrical con­
nection.
AWARNING
Failure to tighten terminal screws can cause a fire
which can result in DEATH, SERIOUS BODILY INJURY,
OR PROPERTY DAMAGE.
9. Replace terminal cover on thermostat and fold insulation
back over the element making sure that the locking tabs on
the terminal cover are in place.
AWARNING
Make sure the thermostat is flush against the tank,
the terminal cover is in place, and tne insulation is
replaced. Failure to do so can result in DEATH, SERI­
OUS BODILY INJURY, OR PROPERTY DAMAGE.
10. Fold the insulation back in place so that it completely cov­
ers the thermostat and element.
0
12. Complete wiring to the water heater, or if completed, turn
“ON” electric power to the water heater after filling the
tank with water,
A CAUTION
Never use this water heater unless It is completely
full of water. To prevent damage to the tank and
heating element, the tank must be filled with water.
Water must flow from the hot water faucet before
turning "ON" power.
14