Appucation, 1 threading and testing – SINGER UT-1 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. APPUCATION :
1-1 THREADING AND TESTING
THE THREADING OF THIS SEWING MACHINE IS THE SAME AS CT
SERIES, PLEASE REFER TO THE USER GUIDE OF CT SERIES
INTERLOCK MACHINE.
PLEASE BE AWARE THAT THE WRONG THREADING IS THE MAIN
REASON TO CAUSE THE SKIP STITCH PROBLEM. IF THE UTA-1
DEVICE IS NOT ASSEMBLY ON THE MACHINE BY OUR FACTORY BLTT
PURCHASE SEPARATELY PLEASE ADJUST AND TEST THE MACHINE
TO REACH THE BEST SEWING EFFECTS ACCORDING TO THE
FABRICS AND .THREAD YOU ARE USING FIRST AND THEN,
ASSEMBLE THE UTA-1 DEVICE AFTERWARDS.
[ DO NOT OPERATE THE UTA-1 DEVICE IF THERE IS NO FABRICS
UNDER THE PRESSER FOOT.
1. START THE SEWING MACHINE BY PUSHING THE PADEL
FORWARD®
2. WHEN PEDAL BACK TO NEUTRAL POSITION © THE SEWING
MACHINE STOP AND AT THIS MOMENT. YOU CAN SET THE
NEEDLE TO ITS UPPER SET STOP POSITION OR LOWER SET STOP
POSITION.
3. WHEN PUSHING THE PEDAL BACKWARD ©THE NEEDLE REACH
ITS UPPER SET STOP POSITION AND STOP THEN TRIMMING KNIFE
START ITS OPERATION TO CUT THE LOOPER THREAD AND
NEEDLE THREADS FIRST THEN CUT THE SPREADER THREAD NEXT
AND PRESSER FOOT UFT UP AUTOMATICALLY.
4. TAKE OFF THE SEWING FABRICS AND PREPARE FOR THE NEXT
SEWING OPERATION.
BEFORE YOU PUSH THE PEDAL FORWARD. YOU CAN PUSH THE
PEDAL BACKWARD AND LIFT UP THE PRESSER FOOT IN ORDER
TO ADJUST THE FABRICS POSITION AT ANY TIME.