Embroidering and monogramming, Darning – SINGER WK-100 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
24. EMBROIDERING AND MONOGRAMMING
Fig. 59
!. Release pressure of presser toot. Lower
fabric feeders. Lock zigzag indicator
into posiiion "Z” under the zigzag
indicator plate. Put material into em
broidery hoop, then place under foc-t.
Lower foot, then turn the fly wlicel
toward you. by hand and raise the
lower thread through the material so
that both the upper and lower threads
are on top of your material.
2. Sew' at medium speed. Move niuterial
slowly so that the thread will be close
together as in a satin stitch. With a
little practice you will be able to do
many types of designs and gain a great
deal of pleasure from your machine.
CAUTION: Work carefully and be sure
to keep fingers out of the path of the
needle.
Fig. 6 0
25. DARNING
1. Release the pressure of the presser
foot. Lower the fabric feeders, and
place the material under the foot and
lower the presser bar.
note
: This enables you to move
the material in any direction while
the machine is running.
2. Sew around the areas you desire to
darn. Then move the material back
and forth, sewing out beyond the worn
or open place in the material. Con
tinue until the hole is covered, going
both sideways and forward and back,
note
: While darning, run the machine
at medium speed.