SINGER W2031 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Notice: You can make the buttonhole without braid or gimp in the same way as

front page.

20.

To sew Buttons

1. Change the presser foot to the Button Foot.

2.

Turn the Drop Feed Knob to “EMBR".

3.

Place material or garment with button under the foot, so that holes in button

line up with oblong hole in the foot (Fig. 26)_.

4.

Adjust the Zigzag Lever so that width

of zigzag stitch permits needle to pass

through center of holes in button.

5.

Sew several stitches and remove mate­

rial from machine and snip thread.

Fig. 26

Notice:

When attaching four-holes button, first sew one set of two holes, then

stitch into second set of two holes and lock thread with two or three

plain stitches in last hole as described above.

21.

To make Hem

1. Use the Hemmer Foot.,

2.

Clip the corner of the material td be hemmed, so that it will be easier for

you to insert the material in the hemmer foot.

3.

Feed the clipped edge of the material by curling it into the spiral tongue or

thè- scroll of the foot. '

(

16

)

4.

At first, it might be necessary for

you to lead the material until

beginning of the hem is just be­

low the needle.

5.

Fewer presser foot and begin to

sew.

6.

Keep guiding the material, so

that the scroll is filled all the time (Fig. 27).

Notice:

Do not crowd the material into scroll and do not leave scroll only partly

filled by the material. Feed just enough material into the hemmer foot

to fill out the scroll. Instead of a straight stitch, you can also use a

zigzag stitch, width of the zigzag stitch-to be as wide as the hem

itself. Using a long stitch and tight tensions will produce a shell stitch.

Fig. 27

22.

How to do Felling

The hemmer foot can also be used for felling. Proceed in the lollowing manner:

I. Lay two piece.s of doth one top of the other with their RIGHT sides facing

each oihc. The right edge of the bottom piece must extend about 18" beyond

the right edge of the top piece. See Fig. 28,

( 17 )

Advertising