SINGER WHA-1 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 8-A
1.
Place a spool of thread on spool pin (A)
and
lead
the
thread
through
the
notched
thread guide (A) on the face plate.
2. Run the thread through the tension discs
(C)
FROM BACK TO FRONT.
3. Draw the thread up over the tension bar
(D) and through the wire check spring (E).
4.
Now take the thread up through the eye
of the take-up lever (F) and down through
the thread gui des (G and H).
5s Thread the needle from left to right, pull
ing about six inches of thread through the
eye of the needle (1).
1.
Place a spool of thread on spool pin (A)
and
pass
the
thread
to
the
left
through
thread guide (.B).
2.
Lead
down
from
right
to
left
between
tension discs (C).
3. Draw the thread up into the take-up spring
(E)
until the thread enters the retaining
fork (D).
4.
Now pass the thread through the hole of
thread take-up lever (F), and down to the
guide (G) on face plate.
5.
Then lead into the wire guide (H) on the
needle clamp and thread the needle from
right to left, drawing about six inches of
thread through the eve of the needle Cn,
13