List of parts complete, High speed. drop feed, Vertical trimmer. binder – SINGER 112W138 User Manual
Page 3: Hook at left of the needle, Instructions for ordering, Machine no. il2wl38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTRUCTIONS FOR ORDERING
In ordering Trom this list, use ONLY the PART number In
the FIRST column.
The number stamped on a Sewing Machine Pari Is the num
ber of the Single Part only, except when the part Includes
Set Screws, Clamping Screws, Studs and Rollers Spun on.
Small Wires riveted, or Parts soldered together, etc.,which
It Is necessary to furnish In combination.
Every combination of parts sent out has Its specific
number which, although not stamped on Parts (except In
above case), must be used when ordering the combination.
Each number always Indicates the SAME PART In whatever
list It appears, or for whatever Machine.
The letters after some of the numbers Indicate the
style of finish only, as follows:
A.
Hardened, Polished, Nickel Plated and Buffed.
B.
Polished, Nickel Plated and Buffed.
C.
Hardened only.
D.
Polished only.
E.
.Soft, not polished.
F.
Hardened and Polished.
H. Blued.
J. Nickel Plated only.
R. Merllzed.
X.
Black Oxide.
XC. Hardened and Black Oxide.
Y.
Blade Nickel only.
These letters MUST BE USED when they appear In the list
and AFTER the number, as In the list.
In this series:
200001
to 201500
and 350001
to 351500 are
Screw Numbers.
201501
to 201800
and 351501
to 351800 are
Nut Numbers.
201801
to 202000
and 351801
to 352000 are
Roller Numbers.
202001
to 350000
are Numbers of Machine Parts.
The figures In the second column refer only to the
plate In which the Illustration of the part Is shown and
are NOT TO BE USED In ordering.
Two or more numbers over a cut Indicate that the dif
ference between such parts Is not visible In an Illustra
tion.
Parts marked with an asterisk (•) are furnished when
repairs are made at the factory.
LIST OF PARTS COMPLETE
FOR
MACHINE No. Il2wl38
HIGH SPEED.
DROP FEED.
VERTICAL TRIMMER.
BINDER.
HOOK AT LEFT OF THE NEEDLE.
MADE IN >/g INCH GAUGE THE TRIMMING MARGIN IS
CONTROLLED BY THE WIDTH OF THE BINDING,
No.
«248176
Píate
Na.me
Arm with 202135 and 2011C01:
2,24002,
16270
M
Cap
20017011
1G270
II
" Screw
20224B
16270
II
" " Washer
2042.35
16260
II
Position Pin (2)
200004E
16260
If
Screw (3)
202005
16260
It
Washer (3)
22,4137
162,70
II
Shaft with 200357F, and 224392
240602,
162,70
II
Bushing (back) with 202244
2022,44
16270
II
" " " Oil Packing
2003.38C
16270
II
" Set Screw
207080
16270
" " (front) with 202244
202244
16270
If
" " " on Packing