SINGER WK-100 - Manual (Page 24)

24. EMBROIDERING AND M0N0GRAMMIN6
Fig. 59
1. Release pressure of presser tool.
fabric feeders. Lirck zigzag indicauii^
into position
under ihc •'ic/.ac
indicator plate. Put maienal intu eiio
broidery hoop, then place under looi.
Lower foot, then turn the fiy wtieel
toward you. by hand and rai.sc the
lower thread through the material so
that both the upper and lower ifireads
are on top of your material.
2, Sew at medium speed. Move nKitenal
slow’ly so that the thread vvif ;re dose
together as in a satin stitch. With a
little practice you will be able to do
many types of designs and gain a great
deal of pleasure from your niuchine.
CAUTION; Work carefully and be sure
to keep fingers out of the path of the
needle.
Fig. 6 0
25. D A R N I N G
1 . Release the pressure of the presser
foot. Lower the fabric feeders, and
place the material under the foot and
lower the presser bar.
NOTE : This enables you to move
the material in any direction while
the machine is running.
2. Sew around the areas you desire to
darn. Then move the material back
and forth, sewing out beyond the worn
or open place in the material. Con­
tinue until the hole is covered, going
both sideways and forward and back.
NOTE : While darning, run the machine
at medium speed.