Binder – SINGER W9951 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
31
*
-.
*
^
/
-
BINDER
This attachment folds bias binding, applies it to the
edge of material in one operation. Slots on scroll of
the binder are for corresponding widths of commercial
folded bias binding.
The
open
mouth
of
binder
scroll
is
used
for
unfolded bias strips cut 15/16 inch wide.
FOLDED BINDING (Fig. 41)
Cut a point on folded binding, insert in appropriate
slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.
TWO-TONE BINDING (Fig. 41)
Two bindings can be sewn on fabric edge also in
one operation. When two are used, always skip one
size between widths, inserting each in correct size slot.
HAND-CUT BIAS BINDING (Fig. 42)
Cut 15/16 inch bias binding fold in half for a
couple of inches. Cut binding diagonally toward end,
almost to fold. Slip fold into center of binder. Draw
back until cut opens and binding encircles open end
of scroll. Test stitching to be sure it is on the edge
adjust if necessary.
Fig. 41
Fig. 42