Step 5: attach ignition ground wire, Step 4: attach starter motor cable – Troy-Bilt 1900678 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Photo 2-19:
Connect recharging line on 24" (8HP en
gine) mower. (Wheel removed for photo clarity).
D.
Use a plastic tie to secure the recharging line to the
strut. See Photo 2-20.
Photo 2-21:
Attach starter motor cable to lower stud oh
solenoid.
STEP 5: Attach Ignition Ground Wire
A.
The ignition ground wire is a thin green wire that
leads from the key switch wiring harness (the wiring
harness also contains a red and a white wire).
B.
At the rear of the engine, remove the nut from the
engine ground stud, attach the wire terminal, and re
place the nut securely. See Photo 2-22 or 2-23.
Photo 2-20:
Add plastic tie to recharging line (wheel
removed for clarity).
STEP 4: Attach Starter Motor Cable
A.
Parts Needed: (1) 5/16"-24 Hex Nut, (1) 5/16" Lock-
washer.
B.
The starter motor cable is a thick red cable, approx
imately 20" long. One end is already attached to the
starter motor at the front, right side of the engine.
C. Bring the cable terminal over to the solenoid that is
mounted on the battery bracket support leg. As shown
in Photo 2-21, attach the cable terminal to the lower
stud on the solenoid and add the 5/16" lockwasher and
5/16" hex nut. Tighten the hex nut securely to ensure a
good electrical contact.
Photo 2-22:
Attach ignition ground wire on 22" (5HP
engine) mower.
Photo 2-23:
Attach ignition ground wire on 24" (8HP
engine) mower.
12