Assembly, Tools required for assembly, Assembly -5 – Husqvarna 917.29939 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed,
(1) Utility knife
(1) Screwdriver
(1) Pair of pliers
(2) 1/2" wrenches
OPERATOR’S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
CONTENTS OF HARDWARE PACK
(1) Manual
(2) Carriage Bolts 5/16-18 UNC x 2-1/2
(2) Flange Locknuts
5/16-18 UNC
(2) Hex Bolts 5/16-18 X 1-1/4
(2) Hex Nuts 5/16-18
(2) Lock Washers 5/16