Campbell Hausfeld CHN70500 - Manual (Page 16)

Operating Instructions and Parts Manual
16
CHN70500
www.chpower.com
rePlACeMeNt PArts
Use only genuine Campbell Hausfeld service parts. Tool performance,
safety and durability could be reduced if improper parts are used. When
ordering replacement parts, specify by part number.
BAttery rePlACeMeNt
Always disconnect the tool from the power source when unattended,
performing any maintenance or repair, clearing a jam, loading,
unloading , or moving the tool to a new location.
The electronics on the tool (low nail indicator lights and nail placement laser pointer)
run off of two (2) AAA batteries located in the compartment on the back of the
magazine. When the batteries’ power is running low and they need to be replaced,
the electronic functions may not work properly or at all. Disconnect the tool from air
source and remove the battery compartment cover by squeezing the locking tab and
pulling out. Insert two (2) new batteries in the proper orientation. Do not mix old and
new batteries. Close cover.
AsseMBly ProCedure For seAls
When repairing a nailer, the internal parts must be cleaned and lubricated. Parker O-
lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube
before assembling. A small amount of oil must be used on all moving surfaces and
pivots.
teCHNICAl servICe
For information regarding the operation or repair of this product, please call 1-800-
543-6400.
FAsteNer INterCHANge INForMAtIoN
Fasteners used in the Campbell Hausfeld CHN70500 Angle Finish Nailer will also work
in the following brand units:
• Campbell Hausfeld NB0064 • Ridgid R250SFA
• Craftsman 18175, 18314 • Senco Finish Pro 32
• Porter Cable FN250
Maintenance (Continued)
Figure 25 - Battery replacement
FAsteNers
The following Campbell Hausfeld brad nails are available at local retail stores. For help locating any item,
call customer service at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.
Model # Length Shank Gauge Finish Head Collation Nails Per Stick Nails Per Box
FB005060 2 inch 16 Gauge Galvanized Brad Adhesive 50 2500
FB160025 1 inch 16 Gauge Galvanized Brad Adhesive 50 1000
FB160040 1-1/2 inch 16 Gauge Galvanized Brad Adhesive 50 1000
FB160050 2 inch 16 Gauge Galvanized Brad Adhesive 50 1000
FB160065 2-1/2 inch 16 Gauge Galvanized Brad Adhesive 50 1000