Throttle control installation, Clutch control rod installation – MTD 213-381A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Screwdriver
Self-Tapping
Screw (C)
THROTTLE CONTROL INSTALLATION
1. Place the throttle control up through the slot
in the handle panel. Secure with two self
tapping screws (C). Tighten securely with a
------ screwdriver. See figure 7.
FIGURE 7.
2. Place the throttle control knob (L) over throttle
control lever. Tap on with a hammer. See
—figure 8.
3. Secure throttle control cable to handle with
cable ties (N). Cut off excess ends.
FIGURE 8.
Hairpin Cotter (J)
Clutch
Rod
Idler
Bracket
Ferrule^
CLUTCH CONTROL ROD INSTALLATION
1. Place shift lever (located on handle panel) in
neutral (N) position. Place bent end of control
rod into shift lever. Secure with hairpin cotter
------ (J). See figure 9.
2. Thread ferrule (H) onto the other end of con
trol rod so that the ferrule lines up with the
hole in idler bracket. Secure with cotter pin (I).
See figure 9.
FIGURE 9.