How to use the elliptical crosstrainer, Exercising on the elliptical crosstrainer, How to adjust the pedals – NordicTrack CX 920 831.28353 User Manual

Page 9: How to adjust the incline frame

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

HOW TO USE THE ELLIPTICAL CROSSTRAINER

EXERCISING ON THE ELLIPTICAL CROSSTRAINER

To mount the elliptical crosstrainer, hold the handgrip
pulse sensor and step onto the pedal that is in the
lowest position. Next, step onto the other pedal. Push
the pedals until they begin to move with a continuous
motion. Note: The pedal disks can turn in either
direction. It is recommended that you turn the
pedal disks in the direction shown by the arrow
below; however, for variety, you may turn the
pedal disks in the opposite direction.

To dismount the elliptical crosstrainer, wait until the
pedals come to a complete stop. The elliptical
crosstrainer does not have a free wheel; the ped­
als will continue to move until the flywheel stops.
When the pedals are stationary, step off the highest
pedal first. Then, step off the lowest pedal,

HOW TO ADJUST THE PEDALS

The motion of the
pedals is deter­
mined by their
position on the
spring arms.
There are five
different pedal
positions. To
adjust the pedals,
first loosen the
knob beneath
each pedal. Slide

the pedals forward or backward to the desired posi­
tion, and then retighten the knobs. Make sure that
both pedals are in the same position.

HOW TO ADJUST THE INCLINE FRAME

As you exercise on the elliptical crosstrainer, you can
vary the effect of the exercise by raising or lowering
the incline frame. First, position the incline wheels
side by side. Next, pull the incline knob as you iift
the incline frame slightly. Raise or lower the incline
frame to the desired position and then release the

incline knob. Move the Incline frame up or down
slightly until the pin on the incline knob snaps
into one of the holes in the incline bracket. Push

the incline knob to make sure that the pin is fully

inserted into the hole.

HOW TO USE THE UPPER BODY ARMS

The upper body
arms are
designed to add
upper-body exer­
cise to your work­
outs. As you
exercise, push
and pull the
upper body arms
in order to work
your arms, back,
and shoulders. To
exercise only
your lower body,
hold the handgrip
pulse sensor as you exercise.

9

Advertising