Lubrication, Air cleaner (see fig. 20), Cooling system (see fig. 21) – Poulan PPRT5C User Manual
Page 14: Customer responsibilities, Engine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CUSTOMER RESPONSIBILITIES
A
Disconnect spark plug wire before performing any maintenance (except carburetor adjustment) to
prevent accidental starting of engine.
Prevent fires! Keep the engine free of grass, leaves, spilled oil, or fuel. Remove fuel from tank before
tipping unit for maintenance. Clean muffler area of all grass, dirt and debris.
Do not touch hot muffler or cylinder fins as contact may cause burns.
ENGINE
LUBRICATION
Change the olí after the first two hours of operation and
every 25 hours thereafter or at least once a year if the tiller
Is not used for 25 hours in one year.
Check the crankcase oil level before starting the engine
and after each five (5) hours of
continuous use.
Add SAE
30 motor oil or equivalent Tighten oil filler plug securely
each time you check the oil level. SAE 5 W-30 motor oil may
be used to make starting easier in areas where temperature
is consistently 32^ F (0°C) or lower.
TO CHANGE ENGINE OIL (See Figs. 18 and 19)
Determine temperature range expected before oil change.
All oil must meet API service classification SG.
•
Be sure tiller is on level surface.
•
Oil will drain more freely when warm.
•
Catch oil in a suitable container.
•
Remove drain plug.
» Tip tiller forward to drain oil.
•
After oil has drained completely, replace oil drain plug
and tighten securely.
•
Remove oil filler plug. Be careful not to allow dirt to
enter the engine.
•
Refill engine with oil. See “CHECK ENGINE OIL
LEVEL” In the Operation section of this manual.
FIG. 18
AIR CLEANER (See Fig. 20)
Replace aircleanercarthdge every twenty-five hours, more
often if engine is used in very dusty conditions.
" Loosen air cleaner screws, one on each side of cover.
•
Remove air cleaner cover.
» Carefully remove air cleaner cartridge. Be careful. Do
not allow dirt or debris to fall into carburetor.
•
install new air cleaner cartridge. Clean and replace
cover. Tighten screws securely.
NOTE: Do not attempt to clean or oil the paper cartridge.
COOLING SYSTEM (See Fig. 21)
Your engine is air cooled. For proper engine performance
and long life keep your engine clean.
•
Clean air screen frequently using a stiff-bristled brush,
•
Remove blower housing and clean as necessary.
•
Keep cylinder fins free of dirt and chaff.
14