Step 4: install the battery cables – Troy-Bilt 12090 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 2: Assembly
STEP 4: Install the
Battery Cables
NOTE: The cabie terminals should be
toward the rear (keyswitch side) of the
battery posts.
1. Use a 5/8" long screw and 1/4-20 hex
nut to connect the positive (+) battery
cable (J, Figure 2-19) to the positive
(marked +) battery post (K). Make sure
that this is the cable on the left side, with
one end attached to the solenoid (Q).
2. Slide the black rubber boot (P) com
pletely over the battery post and cable
connector.
3. Use a 5/8" long screw and 1/4-20 hex
nut to connect the negative (-) battery
cable (L) to the negative (marked -)
battery post (M) and secure with screw
(R) and nut (S).
4. Slide the black rubber boot (T) com
pletely over the battery post and cabie
connector.
5. Make sure that the lower end of the
vent tube shield (U) Is positioned in front
of the wheel shaft axle. Move it there if
necessary.
Figure 2-19: Battery cable assembly.
Assembly is complete for electric start
tillers. See Section 3, Co/7fro/s for
information on tiller controls.
12