Auger chain adjustment, Shifting rod adjustment, Drive clutch control adjustment – MTD 310-430A User Manual
Page 15: Auger clutch control adjustment, Chain guard, Figure 33, Rear axle chain adjustment
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUGER CHAIN ADJUSTMENT
If the drive chain to the auger is loose, it may be
adjusted using a 9/16” wrench. Loosen the hex
nut on the outside of the chain guard on the left
hand side of the unit. Slide the bolt down as
necessary. Tighten the hex nut securely. See
figure 33.
Loosen the two hex nuts at the wheel axle on the
right hand side of snow thrower housing. Lift up
on the right wheel to take the slack out of the
chain as you retighten the nuts. See figure 34.
SHIFTING ROD ADJUSTMENT
To adjust the shifting rod, refer to step number 13
under assembly instructions.
DRIVE CLUTCH CONTROL ADJUSTMENT
To adjust the drive clutch control, refer to step
number 18 underassembly instructions.
Hex Nut
AUGER CLUTCH CONTROL ADJUSTMENT
To adjust the auger clutch control, refer to step
number 22 under assembly instructions.
Chain Guard
FIGURE 33.
REAR AXLE CHAIN ADJUSTMENT
To adjust the rear axle chain, first tip the snow
thrower forward so it rests on the auger housing
and drift cutters.
FIGURE 34.
Lift Right
Hand Wheel
15