MTD 310-430A - Manual (Page 5)

F-~^
G—^ M
A
-K .tlr'
i.
.^W
c-
D-
1
FIGURES.
K V T—**
-»-AB
Contents of Hardware Pack
A (2) Ignition Keys
B (3) Chute Flange Keepers
C (6) Hex Cent. Lock Nut 1/4-20 Thd.
D (2) Self-Tapping Screws #8 x .50” Lg.
E (1) Auger Clutch Grip Assembly—L.H.
F (1) Belleville Washer .34 I.D. X .88 0.D.
— G (1) Hex Nut 5/16-18 Thd.
H (1) Carriage Bolt 5/16-18
X
1.75” Lg.
I (1) Belleville Washer
J (1) Hex Nut 5/16-18 Thd.
K (1) Clevis Pin
L (1) Push Cap
M (2) Cotter Pins 3/32” Dia.x 1.00” Lg.
N (1) Ferrule
O 0) Flat Washer.344 I.D.x.88 0.D.
P (2) Hex Jam Nut 5/16-24 Thd.
Q (1) Lock Washer 5/16” Scr.
S (1) Shift Lever
T (2) Vinyl Tape
U (1) Elastic Lock Nut 3/8-24 Thd.
V (1) Compression Spring
W (1) Belleville Washer .40 I.D. x .88 O.D.
X (2) Carriage Bolts 5/16-18
X .
62” Lg.
Y (2) Lock Washers 5/16” Scr.
Z (2) Hex Nuts 5/16-18 Thd.
AA (2) Hex Screws 3/8-16 X . 88” Lg.
AB (2) Lock Washer 3/8” Scr.
3. To attach handle assembly to the snow
— thrower, first remove the hex screw and lock
washer from each side of snow thrower
housing. A 9/16” wrench is required. See
figure 4.
FIGURE 4.
4. Fasten handle assembly to snow thrower
housing. Place lock washer (AB) on hex screw
(AA). Line up holes in handle with holes in
sides of snow thrower housing. Start hex
— screws into rear holes by hand. Replace hex
screw and lock washer in front hole. See
figure 5. Do not tighten at this time.
FIGURES.
NOTE
Loosen the three hex nuts which
hold the handle panel to the handle.
This will permit handle to move
freely so it can be assembled to the
housing with greater ease. Leave
hex nuts loose.