Caution, Note, Assembly – MTD 310-430A User Manual
Page 4: Instructions, A caution, Figure 1, Assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Æ
CAUTION
The snow thrower is shipped with
out gas or oil. See operating section
of this manual after assembly.
NOTE
Reference to right hand or left hand
side of machine are observed from
the operating position.
ASSEMBLY
INSTRUCTIONS
Tools Required for Assembly
9/16” Wrench
1/2” Wrench
7/16” Wrench or
or One Adjustable Wrench
Screwdriver
Hammer
Block of Wood
Snow Thrower
Remove from Carton
1. Remove snow thrower and all parts from the
carton. Make certain that all loose parts and
literature have been removed before the
---- carton is discarded.
2.
Extend throttle control assembly which is
attached to engine at rear of the snow thrower
and place on floor.
A
CAUTION
Do not bend or kink control wire.
FIGURE 1.
~^lli
(M
Loose
J ■■■ f.
(1)
(1)
Chute- Assombly
Hiindlp
Assembly
(1)
(1) Chute Crank Assembly
(1) Shifting Rod
(1) Clutch Rod Assembly
R.irtr. T.ipnd
Together
FIGURE 2.