Side shield installation, Handle assembly, Note – MTD 219-406-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Insert clevis pin (D) through the tine shield and
depth stake assemblies. Secure with hairpin cot-
—ter (E). See figure 4.
3. Insert hex bolt (A) into the upper hole of the depth
stake assembly. Place flat washer (B) onto the hex
bolt and thread ball knob (C) onto the hex bolt. See
figure 4. Tighten securely.
End Cover
SIDE SHIELD INSTALLATION
Mount side shields (AB) over the weld bolts on the end
cover assemblies. Secure with belleville washers (P)
and hex nuts (Q). Crowned side of washers go against
-the hex nuts. See figure 5.
HANDLE ASSEMBLY
1.
Attach the handle panel to the handles using car
riage bolts (M), lock washers (N) and hex nuts (O).
------- See figure
6
. Do not tighten.
NOTE
To align the holes in the handle panel
and the handle, it may be necessary to
loosen the cable brackets which are
mounted to the back of the handles with
self-tapping screws.