MTD 219-406-000 - Manual (Page 7)

Slot in
Cable Bracket
Tine Control Cable (Attaches to Left Handle)
1, Remove one nut and the lock washer from the end
of the tine control cable. Slip the cable up through
the slot on the cable bracket on the left handle.
Rethread hex nut and lock washer on the end of
the cable. See figure 10. Do not tighten at this time.
FIGURE 10.
2
.
Hole in
Clutch Lever Control Wire
Hook the “Z” end of tine control cable into the hole
in tine clutch lever.
With the clutch lever released (in the “up” posi­
tion), adjust the bottom nut at the cable bracket so
there is only a slight amount of slack in the control
wire. Tighten the upper nut against the bracket.
Squeeze the clutch lever against the handle. The
-control wire should now be straight. See figure 11.
^ NOTE
Do not overtighten control wire. Too
much tension may cause it to break.
Flat End of
Reverse Clutch
Lever
Forward Drive Control Cable
(Attaches to Right Handle)
Attach the forward drive control cable (refer to figure
9) to the right handle in the same manner in which the
tine control cable was attached.
WARNING i
Final adjustment of the forward and
reverse drive cables must be made as
instructed
in the Final Adjustment
section before operating the tiller.
Attaching The Reverse Drive Control Cable
1. Push the flat end of reverse drive clutch lever
------- through the slot in the handle panel. See figure 12.
FIGURE 12.