Generac Power Systems 000595-1 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 6 - Installation
INSTALLATION
PRIMEPACT 70G and 70LP Recreational Vehicle Generators
Vapor seal all compartment seams and joints.
Over the galvanized steel lining, install a combination
of acoustical materials as mentioned in Section 6.2.3.
DANGER
Figure 6.7 - Typical Noise Abatement
A
To prevent fire or explosion, do not install any
insulation or other absorbent materials on the
interior or underside of the compartment floor.
• Seal all compartment door edges to prevent noise
leakage around the door perimeter.
• Line the compartment door interior (except for air
openings)
with
suitable,
fireproof
sound
insulation
(such as 1-inch (25 mm) thick fiberglass with a 2-
pound density).
Figure 6.8
—
Compartment Floor Cutout