5 installation checklist – Generac Power Systems 000595-1 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
Section 7 - Post Installation
PRIMEPACT 70G and 70LP Recreational Vehicle Generators
7.5
INSTALLATION CHECKLIST
♦ LOCATION AND SUPPORT________________________
U Generator is properly located.
J Generator is properly supported.
□ Generator is properly restrained.
♦ GENERATOR COMPARTMENT______________________
□ Compartment construction is proper.
□ Holes/Openings are vapor-sealed.
□ Compartment size is correct.
□ Compartment is vapor-sealed.
□ Sound insulation is correct.
□ Floor cutouts are properly completed.
♦ COOLING AND VENTILATING AIR___________________
□ Airflow is adequate.
□ Air inlet opening is correct.
□ Compensate for restrictions.
□ Check that installation has been tested.
♦ GASOLINE FUEL SYSTEM________________________ _
□ Fuel tank complies with all applicable codes.
□ Fuel system is properly installed and checked
for leaks.
♦ OPTIONAL LP GAS
FUEL
SYSTEM_________________
□ Fuel system is properly installed and checked
for leaks.
□ Pressure at regulator inlet is correct.
□ Rated flow of primary regulator is correct.
□ All parts are properly installed.
□ Fuel system is properly tested/adjusted.
♦ EXHAUST SYSTEM
□ Exhaust system complies with all applicable codes.
□ Exhaust system is properly and safely installed.
♦ ELECTRICAL CONNECTIONS
□ Connections comply with local code requirements
and all National Electrical Codes.
□ Junction box is properly installed.
□ Wiring meets all standards.
□ All connections are correct.
□ Conduit is properly installed and sealed.
□ Generator is properly bonded to the vehicle.
♦ BATTERY INSTALLATION
□ Recommended battery is installed.
□ Recommended cables are installed.
□ Cables are clean and tight.
□ Cables are connected properly.
□ Proper ventilation is provided.
□ Terminals are coated with anti-corrosion grease, and
terminal covers are positioned.
♦ OPTIONAL ACCESSORIES
□ Check that remote starRstop panels (if used) are
installed properly.
□ Check that hourmeter kit (if used) is installed
properly.
□ Check that any other options and accessories (if
used) are Installed properly.
♦ POST INSTALLATION TESTS
□ Check that all tests are completed properly.
DATE OF INSTALLATION
NAME OF INSTALLER
SIGNATURE OF INSTALLER
36 Generac’ Power Systems, Inc.