Oil and fuel information, Oil and fuel mixing instructions, Unleaded gas – Ryobi Trimmer User Manual

Page 9: Ryobi 2 cycle oil, 1 us. gallon + 4.0 fl. oz. (3.8 liters) (120 ml), 1 liter + 30 ml, Mixing ratio - 32:1, Iii. oil and fuel information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OIL AND FUEL INFORMATION

OIL AND FUEL MIXING INSTRUCTIONS

I

|\Oid and/or improperly mixed fuel is usually the

^^Imain reasons for the unit not running properly. Be

■■■■^sure to use fresh, clean unleaded fuel. Follow the
instructions carefully for the proper fuel/oil mixture.

Definition of Blended Fuels

Today’s fuels are often a blend of gasoline and

oxygenates such as ethanol, methanol or MTBE (ether).

Alcohol-blended fuel absorbs water. As little as 1 %

water In the fuel can make fuel and oil separate, it forms
acids when stored. When using alcohol-blended fuel,
use fresh fuel (less than 60 days old).

Using Blended Fuels
if you choose to use a blended fuel, or its use is
unavoidable, follow recommended precautions.

Always use fresh fuel mix per your operator's
manual.

Use the fuel additive STA-BIL® or an equivalent.

Always agitate the fuel mix before fueling the unit.

Drain the tank and run the engine dry before storing

the unit.

Using Fuel Additives

The use of fuel additives, such as STA-BIL® Gas

Stabilizer or an equivalent, will Inhibit comosion and
minimize the formation of gum deposits. Using a fuel
additive can keep fuel from forming harmful deposits in
the carburetor for up to six (6) months. Add 0.8 oz.
(23 ml.) of fuel additive per gallon of fuel according to the
instructions on the container. NEVER add fuel additives
directly to the unit’s fuei tank.

A

CAUTION: For proper engine operation and
maximum reliability, pay strict attention to the
oil and fuel mixing instructions on the 2-cycle
oil container. Using improperly mixed fuel can
severely damage the engine.

► Thoroughly mix the proper ratio of RYOBI

____ 42-cycle engine oil with unleaded gasoline in a
"

separate fuel can. Use a 32:1 fuel/oil ratio. Do

not mix them directly in the engine fuel tank. See the
table below for specific gas and oil mixing ratios.

NOTE: One gallon (3.8 liters) of unleaded gasoline mixed

with one 4 oz. (120 mi.) bottle of RYOBI 2 Cycle
OIL makes a 32:1 fuel/oil ratio.

UNLEADED GAS

ES9

RYOBI 2 CYCLE OIL

1 US. GALLON + 4.0 FL. OZ.

(3.8 LITERS) (120 ml)

1 LITER + 30 ml

MIXING RATIO - 32:1

A

WARNING: Gasoline is extremely flammable.

Ignited Vapors may explode. Always stop the

engine and allow it to coo! before filling the
fuel tank. Do not smoke while filling the tank.
Keep sparks and open flames at a distance
from the area.

A

A

WARNING: Remove fuei cap slowly to avoid
injury from fuel spray. Never operate the unit
without the fuel cap securely in place.

WARNING: Add fuei in a clean, well
ventilated area outdoors. Wipe up any spilled
fuel immediately. Avoid creating a source of
ignition for spilt fuel. Do not start the engine
until fuel vapors dissipate.

NOTE: Dispose of the old fuel/oll mix In accordance to

Federal, State, and Local regulations.

Advertising