Note – MTD 249-620-003 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Protect the inside of the engine for storage as
follows.
Remove spark plug, pour approximately V
2 ounce
(approximately one tablespoon) of engine oil into
cylinder and crank slowiy to distribute oil. Replace
spark plug.
4.
Clean the engine and the entire log splitter
thoroughly.
5. Wipe unit with an oiled rag to prevent rust,
especially wedge and beam.
NOTE
When
storing
any
type
of
power
equipment in an unventilated or metal
storage shed, care should be taken to
rustproof the equipment by coating with
a light oil or silicone.
6. The tongue can be removed and reattached in an
upright position as shown in figure 17 to take less
space when storing.
7. Store unit in a clean, dry area.
FIGURE 17.
13