Generac 1537-0 - Manual (Page 10)

OPEElAnON
Generac Portable Products 2,400 PSI High Pressure Washer
Point the noiizle down towards a firm surface and press
the trigger to test the pattern {Figure 17).
• Twisting the nozzle adjusts the spray pattern from a
narrow pattern to a fan pattern (Figure 18).
Figure 18 - Adjusting Spray Pattern
counterclockwise for fan
spray pattern.
for narrow spray
pattern.
For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from cleaning surface.
If you get the spray nozzle too dose, especially using high
pressure mode, you may damage the surface being
cleaned.
Do Not get closer than 8 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
A
WARNING! You must attach all hoses before
you start the engine. Starting the engine without ail
the hoses connected and without the water turned
ON will damage the pump.
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent, follow these steps:
• Review the use of adjustable nozzles.
• Prepare detergent solution as required by the
manufacturer.
• Hang the detergent solution on the “J” hook attached to
the accessory tray, as shown in Figure 19.
Figure 19 — Insert Filter into Container
into the detergent container.
A
CAUTION! Keep the detergent siphoning tube
from coming in contact with the hot muffler.
• Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with the nozzle in
high pressure position.
• Make sure the garden hose is connected to the water
inlet. Check that the high pressure hose is connected to
the spray gun and the pump. Start the engine.
10