Remove pressure washer from carton, Preparing pressure washer for use, Carton contents – Generac 1537-0 User Manual

Page 5: Attach handle

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Generac Portable Products 2,400 PSI High Pressure Washer

IMPORTANT: Read entire owner’s manuai before you
attempt to assemble or operate your new pressure washer.

REMOVE PRESSURE

WASHER FROM

CARTON

• Remove the parts box included with pressure washer.

• Slice two corners at the end of carton from top to

bottom so the panel can be folded down flat, then

remove ail packing material.

• Roll pressure washer out of carton.

Carton Contents

Items in the carton include:

Main Unit

Parts Box (which includes the following);

Goggles

Handle Assembly

Handle Fastening Hardware (which includes):

Carriage Bolts (2)

Plastic Knobs (2)

“J” Hook

Chemical Hose Clip

Nozzle Cleaning Kit

High Pressure Hose

Quick Connect

Owner’s Manual

Engine Manual

Owner’s Registration Card

Spray Gun

Nozzle Extension

Oil Bottle

O-Ring Maintenance Kit

If any of the above parts are missing or damaged, call the
pressure washer helpline at |-800“270~I408.

PREPARING PRESSURE

WASHER FOR USE

If you have any problems with the assembly of your

pressure washer or if parts are missing or damaged, call the

pressure washer helpline at 1-800-270-1408.

To prepare your pressure washer for operation, you

will need to perform these tasks:

• Fill out and send in the registration card.

• Attach the handle.

• Add oil to the engine crankcase.

• Add fuel to the fuel tank.

• Connect the high pressure hose to the spray gun and the

pump.

• Connect the water supply to the pump.

Attach Handle______________________

NOTE: All assembly operations given in this section will

be described from the perspective of assembling the

pressure washer from the rear.

• Place the handle onto the handle supports already

connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports

(Figure I).

Attach Handle to Base

NOTE: It may be necessary to move the handle supports

from side to side in order to align the handle so it will slide

over the handle supports.

Advertising