Generac 1537-0 - Manual (Page 6)

Generac Portable Products 2,400 PSI High Pressure Washer
Insert the carriage bolt through the holes from the
outside of the unit and attach a plastic knob from the
inside of the unit. Tighten by hand (Figure 2).
Figure 2 — Secure Handle
Add Engine Oil
Insert the “J” hook into the second from the left slot in
the accessory tray (Figure 3).
Figure 3 — Place “J" Hook on Accessory Tray
Pinch the chemical hose that comes out of a hole in the
unit’s base and slide it into the metal clip as shown in
Figure 4.
Figure 4 — Slide Chemical Hose into Metal Clip
attach it to the lower accessory tray flange (Figure 5).
Slide the chemical hose through the metal dip so that it
is tight but not kinked.
Figure 5 — Slide Metal Clip onto Accessory Tray
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break-in. Refer to
engine owner’s manual for recommendations.
Add Gasoline
A DANGER! Never fill fuel tank indoors. Never fill
fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
A WARNING! Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting,
• Use fresh, clean unleaded automotive gasoline and store in
approved, dean, covered containers. Use clean fli!
funnels. Never use "stale” gasoline left over from last
season or gasoline stored for long periods.
• Clean area around fuel fill cap, remove cap.
• Slowly add gasoline to fuel tank. Use a funnel to prevent
spillage. Fill tank to “Fuel Level Mark” (Figure 6).
Figure 6 — Add Gasoline to Fuel Tank
Connect Hose and Water Supply to
Pump
IMPORTANT: You must attach all hoses before you start
the engine. Starting engine without all hoses connected and
water supplied will damage the pump.