NordicTrack NTE11920 - Manual (Page 13)

D SEGMENT TIME
c
c
Note: The console
can display speed
and distance in
either miles or kilo­
meters, To find
which unit of mea­
surement is select­
ed, you must select the console’s user mode. Hold
down the Program Select button for about three
seconds. The letter “E” for English miles or the let­
ter “M” for metric kilometers will appear in the left
display. To change the unit of measurement, press
the + button.
□ SEGMENT TIME
I J l \
fC I
While the user
mode is selected,
press the Program
Start button. The
left display will
then show the total
number of hours
that the elliptical exerciser has been used. Press
the Program Start button again. The left display
will then show the total number of miles pedaled.
To exit the user mode, press the Program Select
button again.
Measure your heart rate if desired.
Note: If you hold the handgrip pulse sensor
and wear the optional chest pulse sensor at
the same time, the console may not display
your heart rate accurately.
If there are
thin sheets of
plastic on the
metal con­
tacts on the
handgrip
pulse sensor,
peel off the
plastic. To
measure your
heart rate,
hold the con­
tacts: your palms must be resting on the upper
contacts, and your fingers must be touching the
lower contacts. Avoid moving your hands.
: SPEED 53 HEART RATE
/
J o
I J o
I RESISTANCE
When your pulse is
detected, the Heart
Rate indicator
above the right dis­
play will begin to
flash, one or two
dashes (—) will
appear in the right display, and then your heart rate
will be shown. For the most accurate heart rate
reading, hold the contacts for at least 15 seconds.
Note: If you continue to hold the pulse sensor, the
right display will show your heart rate for up to 30
seconds. The display will then show your heart
rate along with the other modes.
If your heart rate is not shown, make sure that
your hands are positioned as described. Be care­
ful not to move your hands excessively or to
squeeze the metal contacts too tightly. For opti­
mal performance, clean the metal contacts using
a soft cloth; never use alcohol, abrasives, or
chemicals.
I Turn on the fan if desired.
To turn on the fan at low speed, press the Fan
button. Pivot the fan to the desired angle. To turn
on the fan at high speed, press the Fan button a
second time. To turn off the fan, press the Fan
button a third time.
I When you are finished exercising, the consoie
I
wiil automaticaily turn off.
If the pedals are not moved for several seconds, a
tone will sound, the console will pause, and the
left display will begin to flash.
If the pedals are not moved for about five min­
utes, the console will turn off and the displays will
be reset.
13