NordicTrack NTE11920 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

2. While another person lifts the rear of the Frame (1),

attach the Rear Stabilizer (6) to the Frame with four

IVtS

X

44mm Button Screws (84) and a Support Plate

(104) as shown.

3. Slide a Ramp Cover (48) onto an M6 x 16mm Patch

Screw (76) as shown. Tighten the Patch Screw into

one end of the Pivot Axle (14), which is the longer of
the two axles. Apply a small amount of the included
grease to the Pivot Axle.

Have a second person hold the two Ramp Spacers
(99) against the sides of the Frame (1) so that they

cover the indicated tubes on the Frame. Align the

round tubes on the Ramp (3) with the Ramp Spacers.
Make sure that the Ramp is turned as shown in

drawing 4 below. Insert the Pivot Axle (14) into the

Ramp, the Ramp Spacers, and the Frame. If neces­

sary, tap the Pivot Axle with a rubber mallet to insert it.

Slide a Ramp Cover (48) onto an M6 x 16mm Patch
Screw (76) as shown. Tighten the Patch Screw into the

open end of the Pivot Axle (14).

4. Slide an M6 Washer (64) onto an M6 x 16mm Patch

Screw (76). Tighten the Patch Screw into one end of

the Incline Axle (13). Apply a small amount of grease
to the Incline Axle.

Raise the Ramp (3). Insert the Incline Axle (13) into

the welded tube under one side of the Ramp, through
the motor screw, and then into the welded tube under
the other side of the Ramp. As you insert the Incline
Axie through the motor screw, make sure that the

motor screw does not turn.

Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into the open

end of the Incline Axle (13).

Advertising