NordicTrack C2255 NTL07806.2 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Locate the Reed Switch (22) and the Magnet (18) on

the left side of the Pulley (17). Turn the Pulley until the

Magnet is aligned with the Reed Switch.

Make sure

that the gap between the Magnet and the Reed
Switch is about 1/8”.

If necessary, move the Reed

Switch slightly using a slotted screwdriver. Reattach

the Motor Hood (not shown), making sure that the 3/4”

Screws (not shown) are inserted into the same holes

from which they were removed. Run the treadmill for a
few minutes to check for a correct speed reading.

PROBLEM: The walking belt slows when walked on

SOLUTION:

a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 9.

If the walking belt is overtightened, treadmill perfor­

mance may decrease and the walking belt may be­
come damaged. Remove the key and

UNPLUG THE

POWER CORD.

Using the alien wrench, turn both

rear roller bolts counterclockwise, 1/4 of a turn. When

the walking belt is properly tightened, you should be
able to lift each edge of the walking belt 3 to 4 inches
off the walking platform. Be careful to keep the walk­

ing belt centered. Then, plug in the power cord, insert

the key, and run the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

c.

If the walking belt still slows when walked on, please see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:

a. If the walking belt is off-center, remove the key and

UNPLUG THE POWER CORD. If the walking belt
has shifted to the left,

use the alien wrench to turn

the left rear roller bolt clockwise 1/2 of a turn;

if the

walking belt has shifted to the right,

turn the left

rear roller bolt counterclockwise 1/2 of a turn. Be
careful not to overtighten the walking belt. Plug in the
power cord, insert the key, and run the treadmill for a
few minutes. Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first remove

the key and

UNPLUG THE POWER CORD.

Using

the alien wrench, turn both rear roller bolts clockwise,

1/4 of a turn. When the walking belt is correctly tight­

ened, you should be able to lift each edge of the
walking belt 3 to 4 inches off the walking platform. Be
careful to keep the walking belt centered. Then, plug
in the power cord, insert the key, and carefully walk
on the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.

23

Advertising