Assembly – NordicTrack CXT 980 831.298651 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ASSEMBLY

Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included alien wrenches, assembly requires a phillips screwdriver

,

an adjustabie

wrench

a rubber mallet

c;

, and pliers

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on

page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 X 19mm

Screw (30)-4

M10 X 25mm

Screw (102)-3

M8 Split

Washer (58)-4

M10 Split

Washer (22)-11

M8 Washer

(33)-4

MIO Washer

(63)-2

MIO

X

43mm Screw (65)-4

MIO

X

56mm Screw (60)-4

Ml 0

X

33mm Carriage Bolt (61 )-2

1. Identify the Rear Stabilizer (59), which has Leveling

Feet (14) threaded into it. Attach the Rear Stabilizer to

the Frame with the four M10 x 56mm Screws (60) and
four M10 Split Washers (22).

2. Attach the Front Stabilizer (90) to the Frame (1) with

the four M10 x 43mm Screws (65) and four MIO Split
Washers (22), Make sure that the Front Stabilizer is
turned so the Wheeis (45) are not touching the
floor.

Advertising