NordicTrack CXT 980 831.298651 - Manual (Page 8)

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to
page 19), follow the steps below to install the receiver and
the Y-connector included with the chest pulse sensor.
1. Remove the four indicated screws from the back of the
Console (87). Lift the top of the Console. Be careful
not to disconnect any wires.
2. Peel the paper off the adhesive pad on the back of the
receiver (A). Orient the receiver exactly as shown, and
press it onto the Console (87) in the indicated location.
Connect the wire on the receiver (A) to the Y-connector
(B) as shown. Unplug the indicated console wire (C)
from the indicated jack (D), and plug the console wire
into the Y-connector. Then, plug the Y-connector into
the jack (D).
Refer to step 1 above. Reattach the top of the Console
(87) with the four screws. Make sure that no wires
are pinched.
Note: Any other wires that are included with the chest
pulse sensor may be discarded.
HOW TO USE THE ELLIPTICAL CROSSTRAINER
HOW TO PLUG IN THE POWER CORD
This product
must be
grounded.
If it should
malfunction
or break
down,
grounding
provides a
path of least
resistance for
electric
current to reduce the risk of electric shock. This prod­
uct is equipped with a cord having an equipment­
grounding conductor and a grounding plug. Plug the
power cord into an appropriate outlet that is prop-
eriy installed and grounded in accordance with all
local codes and ordinances. This product is for
use on a nominal 120-volt circuit, important; The
elliptical crosstrainer is not compatible with GFCI-
equipped outlets.
A
DANGER:
Improper connection
of the equipment-grounding conductor can
result in an increased risk of electric shock.
Check with a quailfied electrician or service­
man if you are In doubt as to whether the
product Is properly grounded. Do not modify
the plug provided with the product—if it will
not fit the outlet, have a proper outlet
instatled by a qualified electrician.