Troubleshooting – Ryobi 310BVr User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

ENGINE WILL NOT START

C A U S E

A C T I O N

Choke in incorrect position

Refer to Starting/Stopping instructions on page 13

Empty fuei tank

Fill fuel tank with properly mixed fuel

Primer buib wasn't pressed enough

Press primer bulb fully and slowly 5-7 times until fuel
is visible in the bulb

Engine fiooded

Use starting procedure WITHOUT USING CHOKE

Oid or improperiy mixed fuei

Drain gas tank / Add fresh fuel mixture

Fouied spark piug

Replace or clean the spark plug

Plugged spark arrestor

Clean or replace spark arrestor

ENGINE WILL NOT IDLE

C A U S E

A C T I O N

Air fiiter is piugged

Replace or clean the air filter

Old or improperly mixed fuel

Drain gas tank / Add fresh fuel mixture

Improper carburetor adjustment

Adjust per instructions on page 18

ENGINE WILL NOT ACCELERATE

C A U S E

A C T I O N

Old or improperly mixed fuel

Drain gas tank / Add fresh fuel mixture

Improper carburetor adjustment

Take to an authorized service dealer for
carburetor adjustment

Throttle wire has come loose

Thread throttle wire through the carburetor throttle

lever. Tighten screw.

Dirty air filter

Clean or replace the air filter

Plugged spark arrestor

Clean or replace spark arrestor

ENGINE LACKS POWER OR STALLS

C A U S E

A C T I O N

Old or improperly mixed fuel

Drain gas tank / Add fresh fuel mixture

Air filter is plugged

Replace or clean the air filter

Improper carburetor adjustment

Take to an authorized service dealer for

carburetor adjustment

Fouled spark plug

Replace or clean the spark plug

Plugged spark arrestor

Clean or replace spark arrestor

If further assistance is required, contact your authorized service dealer.

21

Advertising
This manual is related to the following products: