Attaching the seat, Manual adjustment seat, Quick adjustment seat – Bolens 820 thru 829 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Screws
ATTACHING THE SEAT
There are two different seat pivot brackets used on
this series of garden tractor, a manual adjustment
seat or a quick adjustment seat. See Figure 4 and 5
to identify which seat is on your unit. Follow the
instructions which apply to your garden tractor.
MANUAL ADJUSTMENT SEAT
Remove the four screws which secure the seat to
the seat pivot bracket. Turn the seat around and
place in position against the seat pivot bracket, lining
up the slotted holes in the pivot bracket with the
holes in the seat. Select desired position for the
seat, and secure with the four screws. See Figure 4.
NOTE:
Your seat may have been shipped in a
box. Remove the four screws from the bottom of
seat and place seat in position against the seat pivot
bracket. Follow the directions above to attach the
seat.
QUICK ADJUSTMENT SEAT
Pull out tab on seat stop and hold open while sliding
seat out of seat pivot bracket. See Figure 5. Turn the
seat around and line up plastic seat spacers with the
slots in seat pivot bracket. Slide seat in until front
seat spacer engages the seat stop. See Figure 6. To
adjust the seat refer to the adjustment section in this
manual.
NOTE:
If your seat was shipped in a box, line up
plastic seat spacers with the slots in seat pivot
bracket and slide seat in until front seat spacer
engages seat stop.
A
WARNING:
Before operating your unit,
stand behind quick adjustment seat and
pull back on seat, making sure seat is
engaged in seat stop.
Figure 6
10