Linkage, Carburetor adjustments, Sections: lubrication – Bolens 820 thru 829 User Manual

Page 21: Steering gears, Steering shaft, Transaxle, Wheels, Pivot points, Ball joints, Blade spindles

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

LINKAGE

CARBURETOR ADJUSTMENTS

A

WARNING:

If any adjustments are

made to the engine while the engine is
running (e.g. carburetor), disengage all
clutches and blades. Keep clear of all
moving

parts.

Be

careful

of

heated

surfaces and muffler.

Minor carburetor adjustments may be required to
compensate for differences in fuel, temperature,
altitude and load. Refer to separate engine manual
for carburetor adjustment information.

NOTE:

A dirty air cleaner will cause an engine to

run rough. Be certain air cleaner is clean and
attached

to

carburetor.

the carburetor before adjusting

SECTIONS: LUBRICATION

A

WARNING:

Always stop engine and

disconnect

spark

plug

wire(s)

before

cleaning, lubricating or doing any kind of
work on garden tractor.

STEERING GEARS

Lubricate teeth of steering gears with automotive
multi-purpose grease after every 25 hours of
operation or once a season. Refer to Figure 25.

STEERING SHAFT

Lubricate steering shaft at least once a season with
light oil.

TRANSAXLE

The transaxle is lubricated and sealed at the factory
and does not require checking. If disassembled for

any reason, lubricate with 32 oz. of Shell Darina
grease, part number 737-0148 (16 oz. tube).

Once a season lubricate all the pivot points on the
clutch, brake and lift linkage with SAE 30 engine oil.

WHEELS

The front wheels may be provided with grease
fittings. Lubricate at least once a season with

automotive multi-purpose grease.

PIVOT POINTS

Lubricate all pivot points with light oil at least once a
season.

BALL JOINTS

The ball joints and drag link ends are permanently

lubricated.

BLADE SPINDLES

The blade spindles on the cutting deck are
permanently lubricated.

SECTION 10: MAINTENANCE

A

WARNING:

Disconnect the spark plug

wire(s) and ground against the engine

before performing any adjustments, repairs
or maintenance.

TROUBLE SHOOTING

Refer to the trouble shooting chart for information.

ENGINE

Refer to the separate engine manual for engine
maintenance instructions.

Maintain engine oil as instructed in the separate
engine manual packed with your unit. Read and

follow instructions carefully.

Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extremely
dusty condition. To service the air cleaner, refer to
the separate engine manual packed with your unit.

The spark plugs should be cleaned and the gap

reset once a season. Spark plug replacement is
recommended at the start of each mowing season;
check engine manual for correct plug type and gap
specifications.

CLEANING ENGINE AND DECK

Any fuel or oil spilled on the machine should be
wiped off promptly. Grass, leaves, and other dirt
must not be allowed to accumulate around the
cooling fins of the engine or on any part of the
machine.
Clean the underside of the deck after each mowing.

21

Advertising