Safety instructions – AEG 318V User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Safety Instructions
For the
electrical
installer.
To comply wiih safety regulations manufacturers have to draw
your attention to the following:
- According to the technical connection conditions of the elec
tricity board serving your area, the appliance may only be
connected to the mains supply by an approved electrical
installer.
In the. fixed connection, a device allowing the appliance to be
isolated on all poles from the mains supply with a contact open
ing width of at least 3 mm must be provided. Suitable isolating
devices, are line protection switches, fuses (to be removed
from the holder), FI switches and confactors.
Please note that in the case of built-in furniture units the plastic
coating or the veneer must be applied with a heat resistant ad
hesive (100 'C). If the plastic coating and the adhesive are not
heat resistant, it is possible for the coating to deform or be
come detached, particularly along the edges of the built-in fur
niture units.
- in respect of fire protection, the appliance conforms to type Y
(EC 335-2-6). Only appliances of this type may be installed on
one side of adjacent upright kitchen housings or walls,
The distance between a hob and fume extractor hood
must be of the extent indicated in the installation in-
stmctions of the fume extractor hood.