AEG 318V User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The height can be adjusted up from 90 cm to 91 cm or 92 cm
or down from 90 cm to 85 cm to line up with your kitchen furni
ture.
Remove the fixing screws in the plinth, adjust plinth to the
height required and refit screws.
To compensate for uneven floor conditions, you may like to
consider placing a foot (available from AEG Spare Parts De
partment) next to the rear castor.
T
is
;
ITT
^0
850
fW~
Electrical connection
Local and national electrical regulations must be observed,
All instructions given by the Electricity Board must be followed
carefully when connecting the oven to the mains supply.
This is a job for a qualified and approved electrician. The appli
ance is rated for 240 volts single phase and must be permanently
connected.
The cooker must be installed in such a way that it can be easily
disconnected from the mains supply before servicing, e.g., by an
adjacent cooker control unit.
Sufficient cable should be left to enable the appliance to be re
moved from the housing unit whilst still connected to the mains
supply.
WARNING - THIS APPLIANCE MUST BE EARTHED!
Voltage and current
Please ensure that the voltage and current indicated on the rating
plate agrees with the voltage of your electricity supply. 220-240
volts i.e., 220-240 V a.c.
1. Open the cover of the terminal box sideways as illustrated in
fig. G.