Ashly Electronic Amplifier none User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE SHOOTING TIPS
NO OUTPUT
Check AC power - is the pilot light on? Check in/out connections, are
they reversed? Are you sure you have an input signal?
PEAK LIGHT FLASHES OR STAYS ON ALL THE TIME
If the LED continues to flash when all of the crossover level control s
are turned down all the way, it indicates that the crossover is being fed
excessively hot levels from a previous piece of equipment. Turn down
your mixer.' See page 6.
DISTORTED SOUND
Is the peak light flashing? If it is, an overload is occuring within the
crossover, and may also be occurring in other parts of the system. If
the peak light is not flashing, the distortion is occurring somewhere in
the system prior to the crossover.
EXCESSIVE HUM OR NOISE
Hum will usually be caused by a "ground loop" between components. Try
using the suggested balanced input and output hook-ups if the other
pieces of equipment used in conjunction with your equalizer have balanced
inputs and outputs. Noise can be caused by insufficient drive signal.
NOTE:
UN-SHIELDED CABLES, IMPROPERLY WIRED CONNECTIONS, AND CABLE WITH BROKEN
STRANDS (SHORTS ETC.) ARE THE MOST COMMON PROBLEMS. MAKE SURE YOU USE
GOOD QUALITY CABLE.
WHEN IN DOUBT, GET IN TOUCH WITH YOUR ASHLY DEALER, OR CALL THE FACTORY
DIRECT - (800)828-6308. In New York State dial (716)544-5191.
3 7