Assembling the rubber foot and wheels, Assembling the handle, Assembly – Astro Pneumatic 29 Gallon Belt Driven Air Compressor 68127 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
ASSEMBLING THE RUBBER FOOT AND
WHEELS
See Figure 3.
■ Mount the rubber feet as shown in figure.
Tighten firmly with an open-end wrench (not included)
to secure it in position.
■ Mount the wheels as shown in figure.
Tighten firmly with an open-end wrench (not included)
to secure the wheels in position.
WHEEL
NUT
S=
WASHER(s)
RUBBER
©^FOOT
I—WASHER
li—SCREW
SCREW
Fig. 3
ASSEMBLING THE HANDLE
See Figures 4 - 5.
■
Lower the handle onto the compressor body, as shown
in Figure 4.
■
Line the holes of the handle with the ones on the slots
of the compressor. Then insert the two knobs and
tighten firmly to secure the handle in position (Fig. 5).
HANDLE
HOLE OF
THE ANDLE
Fig. 4
KNOB
Fig. 5
12