Bolens 132-698A - Manual (Page 8)

5. Loop one end of battery strap (I) around the
tab on battery box shown in figure 9. Hold the
battery strap out of the way. Place the battery
in the lawn tractor so that the positive ter­
minal is facing the right side of the unit. See
■figure 10.
HI^NOTE
Right and left hand sides of the unit
are determined by sitting on the
seat in the operating position,
facing forward.
FIGURE 10.
6. Secure the battery to the battery box by
stretching the battery strap across the bat­
tery. Loop the end around the tab on the side
—of the battery box. See figure 11.
7. Slide the square nut (provided with battery
hardware) into the positive (-i-) terminal. Place
the positive (heavy red wire) cable and the
small red wire on the positive terminal. Secure
with screw and lock washer provided. See
figure 11.
8. Slide the square nut (provided with battery
hardware) into the negative (-) terminal.
Place the negative (heavy red wire) cable on
the negative terminal. Secure with screw and
lock washer provided.
FIGURE 11.
9. Attach the battery drain tube to the manifold
of the battery, on the left hand side. Push the
locking end of cable tie (J) through the hole in
------ the left frame as shown in figure 12. Route the
battery drain tube back to the cable tie. Place
end of cable tie through the slot so a loop is
formed around the drain tube to secure it.
Tighten cable tie and cut off excess end.
10. Plug the green safety wire into the switch
beneath the transmission cover. Refer to
figure 8. Replace the transmission cover and
gear shift knob.
FIGURE 12.