Air cleaner, Cleaning engine and blade housing, Belts – Bolens 137-465A User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Variable Speed—

See page 28.

Front Pivot Bar—

Lubricate at least once a season

with light oil.

Steering and Drag Link—

Should be lubricated

once a season with light oil.

Lubricate the four rear axle bearings with SAE

30 oil once a season. See figure 19.

The chain can be lubricated by wiping it with an
oily rag.

The differential and transmission are sealed at the
factory and require no further lubrication.

FIGURE 19. REAR AXLE ASSEMBLY

CHAIN ADJUSTMENT

To tighten the chain, loosen two locknuts on each
side of rear axle as shown in figure 19.

Tighten the adjusting nuts (figure 20) equally on
both sides. Tighten until the chain has

Vz

inch

slack between the sprockets.

The adjusting nuts can be tightened individually
to align the axle.

Tighten the 4 locknuts after the adjustment is

made.

Adjastingi

%

Chain

FIGURE 20. CHAIN ADJUSTMENT

AIR CLEANER

Under

normal

operating

conditions,

the

air

cleaner, located on top of the carburetor, must be
serviced after every ten hours of use. Under
extremely dusty operating conditions the air
cleaner must be serviced after every hour of
operation. Refer to figure 21.

When assembling the air cleaner, make certain the

lip of the foam element extends over edge of the

air cleaner body. The foam element will form a

protective seal.

Step 1. Remove two screws and lift off complete

air cleaner assembly.

Step 2. Remove screen and spacers from foam

element.

Step 3. Remove foam element from air cleaner

body.

Step 4. a. Wash foam element in kerosene or

liquid detergent and water to remove

dirt.

b. Wrap foam in cloth and squeeze dry.

c. Saturate foam in SAE 30 engine oil,

then squeeze out excess oil.

d. Assemble parts, fasten to carburetor

with screw.

CLEANING ENGINE AND BLADE HOUSING

Any fuel or oil spilled on the machine should be
wiped off promptly. Grass, leaves, and other dirt

must not be left to accumulate around the cooling
fins of the engine or on any part of the machine.

Clean the underside of the blade housing after
each mowing.

BELTS

Check that belts are free of oil or dirt. Wipe the

belts periodically with a clean rag.

11

Advertising
This manual is related to the following products: