Bolens 137-465A - Manual (Page 7)

c. Brake. The brake pedal is located on the right
hand side of the mower and is operated by
depressing it with your right foot. See figure 9.
d. Brake Lock. The brake lock is located on the
right hand side of the mower. To lock the brake,
depress the brake pedal and lift up the lock
button. The pedal will stay depressed. To release,
depress the pedal. See figure 9.
e. Clutch Pedal. The clutch pedal is used to
disengage the drive mechanism. Depressing _die
clutch pedal at any time will reduce mower speed.
Trdep'ressed all the way,TTwTn stopTheHmow^.
''SeeTtgurn^O:---------------------—------------ -
f. Clutch Lockout. When the clutch pedal Isl
depressed all the way it can be locked by placing'
the clutch lockout in the START position as
shown in figure 10. The clutch locknut must be in |
this position before the engine will start.
g. Stop Lever. The stop lever allows you to
regulate the maximum ground speed of the riding
mower by setting the stop lever in any one of the
five settings. The farther forward the stop lever is
set, the faster the ground speed. See figure 10.
h. Ammeter. (Electric Start Model Only) The
ammeter registers the rate of battery charge or
discharge. The ammeter should register on the
plus side ( +) when the engine is running the fast
position until the battery is completely charged.
With a fully charged battery or with the engine
idling the ammeter will not show a charge. See
figure 7.
C
O O
il
3
c <ra
i. Light Switch. (Eiectric Start Oniy) Pull the light
switch out to turn on the lights. The lights will
only operate when the engine is running. See
figure?.
j. Ignition Switch. The ignition switch is located
on the right side of the dashboard.
Recoii Model. See figure 11. Turn the key to the
ON position when starting the engine. To stop the
engine turn the key to the left to the OFF position
and remove the key to prevent accidental starting.
Electric Start. See figure 7. Turn the key to the
START position to start the engine. When the
engine is running, let the key return to the ON
position. To stop the engine, turn the key to the
left to the OFF position and remove it to prevent
accidental starting.
NOTE
The engine will not start unless the
clutch lockout is in the START posi­
tion and the lift lever is in the DIS­
ENGAGED position.
Lift and Disengagement
Lever (Shown Disengaged)
FIGURE 9. RIGHT HAND CONTROLS
Clutch Lockout
(Shown in the Start Position)
•av:
FIGURE 8. SHIFT PATTERN
FIGURE 10. LEFT HAND CONTROLS