Tool operation, Switch, Blade replacement – Black & Decker 3382 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Figure 2
1
/
2
"
(12.7 mm)|«.
2-3/8"
(60 mm)
(flat biscuits) #20
3/8"
(9.5 mm)|**
2-3/16"
(56 mm)
5/16"
(8 mm
1-13/16"
(46mm)
#10
Figure 3
EDGE TO EDGE JOINT
~1 r~
I——
EDGE
MITRE
JOINT
CORNER
JOINT
r
OFFSET
TOOL OPERATION
OFFSET JOINT
Switch
Your plate joiner has a trigger switch located on the underside, as shown in
Figure 1 A. To turn the tool on, depress the trigger. To turn the tool off, release
the trigger. To lock the tool on for continuous operation, there is a lock on but
ton located at the rear of the tool just above the cord. When cutting always
hold the tool with one hand on the switch handle and one hand on the auxil
iary handle. To lock the tool on, depress and hold the trigger as you depress
the lock button. Hold the lock button in as you gently release the trigger. The
tool will continue to run. To turn the tool off from a locked on condition,
depress and release the trigger once.
Blade Replacement
In time your saw blade will wear out and need replacement. To remove the
blade, follow the steps below.
1. TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
2. Remove the 4 torx head screws from the bottom of the shoe, using the
T20 torx screwdriver provided.
3. Rotate the shoe out of the way.