Radio reception, Tuning in to a station, For quick tuning – Aiwa XP-R970 User Manual

Page 18: For better reception, Note, Am/fm steps

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising

RADIO RECEPTION

English

Tuning in to a station

1 Press TUNER ON/BAND repeatedly to select AM

or FM.

2 Press TUNING + (►►!) or — (M^) to tune in to a

Station.

After listening, press ■STOP/OFF/CHARGE to turn off

the radio.

For quick tuning

Keep either TUNING + (►►I) or — (M^) pressed for 1

or 2 seconds. When a station is tuned in to, the frequency
stops automatically. However, it does not stop if the

broadcast signai is weak.

For better reception ©

FM: The headphone cord functions as the FM antenna.

Keep it extended.

AM: Turn the unit to find the position which gives the

best reception.

To iisten to an FM stereo broadcasting

Press MONO/ST repeatedly to display STEREO.

When the FM stereo signal is weak and distorted, press

MONO/ST again. STEREO display goes out and the

sound will be heard in monaural but distortion will be

reduced.

Note

• Do not open the disc compartment during radio

reception. The buttons will be deactivated.

• The power is turned off automatically if no operation is

made after 3 hours from the last operation during radio
reception.

• Radio broadcasts have different frequency ranges and

changes in different steps in different countries.
This unit is factory-set to 10 kHz steps on AM. When

using the unit where the AM step changes 9 kHz, set

the AM STEP switch in the battery compartment to

9 kHz.

Advertising