Aiwa TS-W45 - Manual (Page 6)

POSITIONING
B-1
Because low-frequency sound reproduced by the powered
subwoofer is mostly non-directlonal, the listener will be unable to
localize the bass source. Accordingly, the powered subwoofer
provides maximum flexibility in terms of positioning. For the most
effective low-frequency sound, the powered subwoofer should be
placed on the floor close to a wall or in a corner of the room.
CONNECTIONS
Connect the speaker cords before connecting the AC cord.
Connect in □ way if your stereo system has a SUPER
WOOFER output jack, if not, connect in [0 way.
Never connect in both of □ and □ ways simuitaneousiy.
□ Connecting an AIWA stereo system with
a SUPER WOOFER or SUB WOOFER
output jack (RCA phono jack) to the
powered subwoofer
Preparations
Turn off the power of this unit.
1 Connect the SUPER WOOFER or SUB WOOFER jack on the
stereo system side
O
to the INPUT 1 (FROM SUPER
WOOFER TERM INAL) jack on the powered subwoofer © with
the supplied connecting cord.
2 Set the INPUT SELECT switch to “1”.
□ Connecting a stereo system with typical
L and R speaker terminals to the powered
subwoofer
Preparations
Turn off the power of the stereo system and remove the speaker
cords from the speaker terminals on the system.
1 Connect the stereo system speaker terminals O to the INPUT
2 (FROM SPEAKERS OUT) terminals on the powered
subwoofer © with the supplied speaker cords O.
Make sure the L and R and the ® and © cords are connected
correctly.
2 Using the speaker cords removed in “Preparations” above,
connect the right and left speakers O © to the SPEAKERS
OUT terminals on the powered subwoofer ©.
3 Set the INPUT SELECT switch to “2”.
Connecting the AC cord
Connect the AC cord to a wall outlet.
Use left/right speakers whose impedance corresponds with the
value specified on the stereo system.
6